Posted by on May 11, 2017 in Plumbing |

I never forget the time I lived in this old home that had out dated sink plumbing and electrical wiring. I remember being faced with sink plumbing issues each week it appeared. Every time I had to work on the sink or other plumbing fixture I had to shut down the water to the entire house. I then chose enough of this and set up shutoff valves under the sinks. Considering that then, I replace many plumbing components in my 38 plus years in the renovation business that I own and operated.

For those who are faced with that same issue or if the shutoff valves need replacement and wish to conserve some money. Follow the steps listed below.

Tools:

  • Mini tubing cutter
  • Basin wrench
  • Adjustable wrench or wrenches
  • Screw motorist
  • Reamer brush
  • Propane torch
  • Flux brush
  • A Fire extinguisher if readily available in case of a fire – or have some water readily offered.
  • Plumber’s emery fabric

Generally sinks and toilets have a fixture shutoff valve. Shut off these valves if you are dealing with any of these components. If the task includes cutting water lines supplying a cooking area sink or a flush tank and there is no component shut off valve, I recommend that this is the perfect time to set up one. If you’d rather not deal with this headache, why not just hire an experienced plumber company like Endeavour Plumbing​, with them you just can’t go wrong!

To install a shut down valve.

Turn the water pipe off and turn on the faucet of the fixture you are working on. Also, switch on a faucet from a lower level to drain pipes the water lines that you are dealing with. Detach the supply line from the faucet and heat the fitting that is soldered to the 1/2 inch water system line and different it from the water line by pulling and twisting it with pliers. Be mindful not to bend the pipeline out of round.

Utilize a cloth to wipe off as much solder as possible while the solder is still hot. Wear gloves to protect yourself from getting burned. Let the pipe cool down and clean it with plumbing technicians emery cloth and dry fit the component shutoff valve to make sure it fits. If it does not fit, clean it again up until the valve fits. Tidy the within of the valve (completion that goes on the copper pipe) with a reamer brush.

After taking the shutoff valve off, separate the stem from the valve by undoing the nut that keeps it in place. If you don’t the seals will get messed up from the extreme heat when soldering, experienced plumbers know this and that’s why they’re extra careful when they’re dealing with the job, if you’d like to work for such a plumber in order to get some experience then you should contact Endeavour Plumbing, you can find their details here​. Apply flux to both the end of the copper pipe and the within of the shutoff valve. Fit the shutoff valve back on the copper pipeline and heat it near the end that goes on the copper pipeline. When the flux begin to sizzle use the solder around the joint where the valve fulfills the copper valve.

Note: Bend the solder into a hook 2 or 3 inches long and begin soldering from delegated right up until it start dripping from the bottom.

Clean off the solder with a fabric while it’s still hot and then let it cool off before putting the stem back on. Follow the exact same treatments for both supply lines.

Shut the valves off, turn the water pipe back on and test for leaks

Next action is to connect the brand-new supply lines to the sink faucets I want to use the braided stainless steel type. They are simple to deal with and lasts a long time. Tighten up all connections and check for leakages this time turn on the shutoff valves. If you encounter leakages, tighten the fitting where it is leaking until the leakage stops.